Subj : Re: Compiling Huskybse To : Al From : Avon Date : Sun Jan 10 2021 21:03:10 On 09 Jan 2021 at 11:49p, Al pondered and said... Al> Av> 2) I think I duffed up a setting in the huskymak.cfg and set Al> Av> CFGDIR=$(PREFIX)/hub/husky Al> Al> You can take the $(PREFIX) out and put your own path if you like. Al> CFGDIR=/path/to/my/husky/directory OK thanks Al> Av> /usr/local/hub/husky does not seem to be created nor does there seem Al> Av> a config file in there, should I have expected to see a default one t Al> Al> No, you will need to create that directory along with a config of your Al> own. OK cool, thanks I wasn't sure if it was going to create a default cfg file for me. Al> There are examples to start you off in hpt/config and htick/misc. There Al> are examples in other directories too.. you'll need to work through that. Al> Al> I can send you my configs in a zip if you'd like to have a look. Thanks yes please, I did have some from you ages ago but it wouldn't hurt to see them now, so thanks. Al> Av> 3) If I were to start over now by making a change to the config file, Al> Av> safe to remove the compiled files from /usr/local/bin (do I do that Al> Av> first?) then run the make and make install process again thereafter? Al> Al> Yes, you can just delete them and start fresh. I like the binary files in Al> /usr/local/bin since that directory is on the path. You can put them Al> anywhere but if they are not on the path you have to use ./hpt or Al> ./htick to run them. You make a good point about pathing. I may do the same then. If I do move I guess I need to change the group:owner to me and find a way to add the dir I move them to the path So because I compiled the first attempt of all my binaries with the wrong pathing to my intended config file, those compiled binaries need to be deleted and recompiled else they will always look to the wrong location for config info - is that right? --- Mystic BBS v1.12 A46 2020/08/26 (Windows/32) * Origin: Agency BBS | Dunedin, New Zealand | agency.bbs.nz (21:1/101) .