Subj : WinPoint Version 403
To   : All
From : Tim Schattkowsky
Date : Fri Mar 04 2022 13:46:16

Updated to 403. Should fix an issue where WP attempts to WRITE to a language file. Also, areas with inactive uplinks are now grey in the area tree.

http://winpoint.org/wpoint_403.zip

>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<
> This message has been _forwarded_! The original message was:              <
>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<
>    Area: *WINPOINT*
>    From: *Tim Schattkowsky(2:240/1120.29)*
>      To: *All*
> Subject: *WinPoint Version 402.1*
>    Sent: *03.03.22* *19:31:22*
>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<

Hello, 

in addition to IPv6 support, some People may also like the new "compact" message
list layout that comes up when you set the message pane to be on the right
(rather than bottom) and make the message list small enough (about less than one
third of the screen) ... 

Regards,
Tim

>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<
> This message has been forwarded! The original message was:              <
>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<
>    Area: WINPOINT
>    From: Tim Schattkowsky(2:240/1120.29)
>      To: Rinaldo Visscher
> Subject: Re: IPv6 support
>    Sent: 03.03.22 19:23:38
>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<

Hello Rinaldo,

on 02.03.22 at 7:50:03 You wrote in Area WINPOINT
to Tim Schattkowsky about "IPv6 support".

 TS>>>> I checked. Indeed there is a single point where the software processes
 TS>>>> the adress that is not working for IPv6. Basically pretty easy to fix,
 TS>>>> ONCE I find or build the necessary header files to use WinSock2 under
 TS>>>> Delphi 2007 ...
 TS>>  MvdV> That is good news. :)
 TS>> Works now.
 RV> When can I test it?

It is available as a binary only (including language files - just in case) from

http://winpoint.org/wpoint_402_1.zip

Just drop the files into the installation directory. I did not create an
installer because I have back problems since yesterday. Probably I have been
sitting for too long ...

Regards,
Tim

-+- WinPoint 402.1
 @ Origin: Original WinPoint Origin! (2:240/1120.29)
>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<
>                      End of forwarded message                             <
>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<
-+- WinPoint 402.1
 @ Origin: Original WinPoint Origin! (2:240/1120.29)
>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<
>                      End of forwarded message                             <
>-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-<

Regards,
Tim
--- WinPoint 403.0
 * Origin: Original WinPoint Origin! (2:240/1120.29)

.