Subj : Bug report To : Joe Delahaye From : Roy Witt Date : Fri Mar 23 2012 04:54:01 22 Mar 12 21:37, Joe Delahaye wrote to Roy Witt: >> MvdV> I have a beta running on my point system. Haven't seen that >> one MvdV> crash, but then again it is not used for incoming calls. >> >> 2.31? I'm still using 2.29... >> JD> I h ave been running 2.31 for quite a while now. No problems that I JD> have found. I may have missed some though What I find JD> irritating about Irex is the fact that it will NOT do a nodelist JD> lookup if I send to a specific node, not in its own nodelist. I came across that when setting up Irex to act more like a hub...I found a fix for it, but don't remember what it was. At any rate, Rex will use the nodelist to send mail, at least it does here. JD> I seem to recall that it was supposed to do so If all else fails, Rex will also use your route.rex file to send mail to a non-Rex configured system listed there as crash-to. i.e. I have crash-to the Z1 Fnews editor in the route.rex file and no Irex node configuration entered for the 1:1/1 nodelisting. You may or may not have noticed that in the very first config section of Rex, you can choose to send mail to 'nodelisted systems only' or send mail to unlisted systems. Check that setting and you may have solved your nodelist usage problem. R\%/itt ... Only those who will risk going too far can possibly ... find out how far one can go ~ TS Eliot --- Twit(t) Filter v2.1 (C) 2000-10 * Origin: Roiz Flying \A/ Service * South Texas * USA * (1:387/22) .