Subj : One entry point, multiple destination points. To : mark lewis From : Eric Renfro Date : Sat Sep 19 2015 13:40:17 Re: One entry point, multiple destination points. By: mark lewis to Eric Renfro on Wed Sep 16 2015 09:04 pm ML> 16 Sep 15 10:21, you wrote to All: ER>> Alrighty. It's been ages since I've used FastEcho, and though I'm ER>> not personally using it, instead trying to help someone else whom ER>> already has it use it, whom is not very savvy with it all. ML> ok... ER>> Here's the situation. One of my downlinks wants to setup their IRex ER>> and FastEcho on thheir system to receive mail, one from me, one from ER>> another link. ML> should be a pretty standard setup... ER>> They run multiple BBS systems at the same time using some telnet2bbs ER>> link tool of some kind, I'm not entirely sure about that, but their ER>> BBS's support includes JAM message bases so.. ML> ok... hummm... are they sharing the same JAM bases between those BBSes?? ML> do they all use the same FTN address? if not then they will need a FE ML> setup for each BBS instance... even if they are all on the same machine... ML> that means either copying packets destined for the others to their ML> inbounds or using some mailer to send to them as normal... i have 4 or 5 ML> systems here all using their own mailers for this but they all also have ML> their own FTN addresses as required... No sharing or JAM message bases, all completely independant of each other. Ideally, not sharing the same FTN address, but if that is possible, then it could be viable, though I'd think a point node would be better personally. Have one BinkD server act as the primary node for the whole list of internal BBS's, and then serve out to each point from there acting as the gateway. That reduces my redundant load, and puts them in proper control as a point-node should be, since he only runs a mailer on one system and one mailer, IRex, and all on Windows, which I haven't touched much for years. :) So, here's the question of all questions then. How do you determine which PKT is for which address, or can you easily? If that's reasonably plausible then, hmmm.. I know sort of the concept, but I've never done this setup myself, always had many different systems to work with, or these days, multiple systems and multiple virtual machines. :) ER>> Can anyone help me come up with a reasonably logical idea of how to ER>> set up this link to receive mail from me and internally relay it to ER>> several point point nodes for their multiple BBS systems they have ER>> running? ML> other than the above ""hints"" for multiple BBSes behind one IP, the setup ML> should be no different than any other distribution hub system... the ML> specific points being that each system has its own FTN address (full node ML> or points) and that there is a proper entry in the nodelist pointing to ML> each domain and/or IP address... Hmmm. Definitely a bit more difficult than I imagined. I keep wanting to utilize his linux system, but he's not so keen on that. But, with it, I could make it handle most everything fairly well, up until it has to still handle mail tossing to the various Windows system's BBS systems, then that situation comes right back to a system with multiple point nodes and BBSs to toss to. heh. Is it unreasonable to assign multiple nodelist entries to someone running multiple BBS's even if they're behind a single IP/mailer, and just have my side route all their IP's to their respective mailers? Coming from an NC perspective on that question. hehe )))[Psi-Jack -//- Decker] --- SBBSecho 2.27-Linux * Origin: Decker's Heaven -//- bbs.deckersheaven.com (1:135/371) .