Subj : Re: RFC seriously
To   : mark lewis
From : Ian Segers
Date : Mon Dec 01 2014 18:53:00

Hello mark lewis 


 ml> this seems to indicate that you are trying to operate your mailer in 5D
 ml> format when your tosser (sbbsecho) is only 4D... you must operate your
 ml> mailer in 4D also... that means that you'll have only one outbound
 ml> directory defined and others will be derived from it... all domains
 ml> will appear the same... it is the zone addresses that will make the
 ml> difference...

  I unticked the 5d outbound in Taurus path config, didn't make much differnce
unless
  there is same were else I was meant to do it. 


 ml> what is your outbound directory definition in ?

         in sbbsecho.cfg is d:\bbs\fd\outbound\ 

 ml> what is your outbound direcrory definition in argus/radius/taurus?


    in rgus/radius/taurus its D:\bbs\fd\outbound

 IS> netmail in taurus outbound  via *.msg the *.msg there but @
 IS> 3:770/330@fidonet which is my address
 IS> if the netmail is in pkt form in dir of out in taurus outboound its
 IS> @ 3:770/330@fidonet with no pkt attached

 ml> this is hard to understand... PKT names are 8.3 format... are you
 ml> trying to use taurus' dynamic netmail packing capability? taurus and
 ml> sbbsecho should not know of the other's MSG directory... sbbsecho
 ml> handles its MSG directory all on its own and in its own special way...
 ml> it is much different than what other mailers would expect...

    Should I have the dynamic netmail packing capability unticked in
    taurus netmail preference.

Ian



.... http://www.1stchoicecore.co.nz...drop in same time
--- MultiMail/Win32 v0.49
--- SBBSecho 2.12-Win32
 * Origin:  (3:770/330)

.