Subj : RFC seriously
To   : Ian Segers
From : mark lewis
Date : Sun Nov 30 2014 05:44:48


 On Sun, 30 Nov 2014, Ian Segers wrote to Bj”rn Felten:

 BF> how do you put it in the proper "OUT" directory?

 IS> When I process this message via sbbsecho.exe, it goes to the taurus
 IS> outbound but as 1:340/400@outbound I have to manual change it to
 IS> 1:340/400@fidonet then works

this seems to indicate that you are trying to operate your mailer in 5D format 
when your tosser (sbbsecho) is only 4D... you must operate your mailer in 4D 
also... that means that you'll have only one outbound directory defined and 
others will be derived from it... all domains will appear the same... it is the 
zone addresses that will make the difference...

what is your outbound directory definition in sbbsecho.cfg?
what is your outbound direcrory definition in argus/radius/taurus?

 IS> netmail in taurus outbound  via *.msg the *.msg there but @
 IS> 3:770/330@fidonet which is my address
 IS> if the netmail is in pkt form in dir of out in taurus outboound its
 IS> @ 3:770/330@fidonet with no pkt attached

this is hard to understand... PKT names are 8.3 format... are you trying to use 
taurus' dynamic netmail packing capability? taurus and sbbsecho should not know 
of the other's MSG directory... sbbsecho handles its MSG directory all on its 
own and in its own special way... it is much different than what other mailers 
would expect...

)\/(ark

 
* Origin:  (1:3634/12)

SEEN-BY: 229/426 103/705 218/720 214/22 102/401 103/1 218/215 840 301/1
SEEN-BY: 218/860 880 601 870 930 124/5016 218/700 1 10/1 218/0 10/0

.