Displays That Are Incompatible with Windows Version 3.1
-------------------------------------------------------
Certain display adapters can cause problems with Windows
version 3.1. The most serious problem is a system
failure while running Windows Setup. If you encounter this
problem, run Custom Setup, and then select one of the standard
display types, such as VGA, provided with Windows version 3.1.

With other display drivers, Windows may be set up successfully
but TrueType fonts may not appear correctly on your screen.
An updated driver may be available in the Windows Driver
Library or from your display vendor or manufacturer. For
information about obtaining the Windows Driver Library,
see "Getting Started with Microsoft Windows."

The following display adapters may cause problems:

-  ATI Graphics Ultra and Vantage

   NOTE: These adapters are 8514/a-compatible and run well
         with the 8514/a driver provided with Windows 3.1.

- All DGIS display adapters (Direct Graphics Interface Standard)
  from Graphic Software Systems, including the following:
        NEC MultiSynch Graphics Engine (MGE)
        Zenith Z-649
        HP IGC-10, IGC-20
        GSS 1000 Series

   NOTE: Some DGIS-based adapters are TIGA-compatible and
         run well when used with the appropriate TIGACD.EXE
         MS-DOS driver and with the TIGA driver provided with
         Windows 3.1.

- HP Ultra VGA
- IBM Image Adapter/A
- Matrox MG Series/M-WIN Series
- Palettized VGA 640x480, 16-color (provided with Windows
  Multimedia Extensions version 1.0)
- Radius SVGA MultiView

- All RGDI (Renaissance Graphics Device Interface) display
  adapters from Appian, Inc., including the following:
       Appian Rendition II, IIe, II/XE, and III
       Appian GV1024
       Decpc 433

- All S3 adapters, including the following:
      Orchid Fahrenheit 1280
      STB WIND/X
      Diamond Stealth VRAM


.