發信人: cooleo (BWS)    看板: airsoftgun
日期: Fri May 16 01:38:54 2003
標題: Re: Kar98k小疑問
來源: 中山大學-美麗之島BBS WEB-BBS

> ==> YaoPeifu (俄國來的John) 的文章中提到:
> > ==> clotho (SG550到手~~) 的文章中提到:
> > 可以請問一下,那是有何作用呢?
> 以我破破的日文,看TANAKA的說明書解釋.
> 應該是拆下槍機栓後,還要再分解時需要用到的東西.
> 有人有正解嗎?!

終於翻到K98 M48型的細部分解
都是英文
f. Disassemble the Firing Pin Assembly, which consists of the Firing Pin,
the highly compressed Firing Pin Spring, the Bolt Sleeve, and the Cock-ing
Piece.
   i. Caution: Notice that the firing pin protrudes about 2" beyond the
front of the compressed spring. Be careful not to bend it when
compressing the spring. Do not apply force to the tip of the firing
pin. It is best if you have a work table or a block of wood with a
small hole into which the front of the firing pin will fit, right up to
the squared off enlarged portion just in front of the spring. (If this is
not available to you, do not proceed.)
   
   ii. Caution: From this point on you will be dealing with a highly com-press
ed
and powerful spring. You must wear eye protection. If you
don’t have it, stop the procedure until you get eye protection be-cause
you will be decompressing and compressing the spring (in the
re-assembly process).

   iii. Compress the spring: With the firing pin inserted into the work
table hole, firmly grasp the bolt sleeve while leaving the cocking
piece free to move. This takes considerable pressure and strength.
Exert downward pressure on the bolt sleeve, compressing the
spring until the cocking piece can be freely turned 90 degrees in
either direction (you may well need some help here).
   
   iv. Remove the cocking piece: With the cocking piece turned 90 de-grees,
you can slowly relax your downward pressure on the spring
tension and the whole assembly will come apart. Note which side of
the firing pin is up, so you can reassemble it the same way. The
firing pin and its spring will come apart (you can see how powerful
it is) as well as the bolt sleeve and safety lever. Swing the safety
lever over to full right (otherwise it won’t come off) and then pull it
straight back. It will come right out.
    
    v. Now you can clean everything in detail. You won't want to disas-semble
the bolt too often (for obvious reasons). You can see that
the firing pin and its spring live deep inside the bolt body so you
want a light film of oil over the entire surface of all parts; espe-cially
inside the bolt body. Never use grease inside the bolt, it
could cause a failure to fire.

可惜該型槍托無小孔
所以叫使用者插在工作桌上的圓孔
還不建議使用者這樣搞....

--
心以虛空而納實
--
* Origin: 中山大學-美麗之島BBS * From: 218.162.160.162 [未通過認證]
.