(TXT) View Source
       
       # STANDARD MICROSYSTEMS CORPORATION
       
          WD8003EB
       
          NIC Type         Ethernet                                      
          Transfer Rate    10Mbps                                        
          Data Bus         8-bit ISA                                     
          Topology         Linear bus                                    
          Wiring Type      RG-58A/U 50ohm coaxial                        
                                                                         
                           AUI transceiver via DB-15 port                
          Boot ROM         Available                                     
       
 (IMG) IMG 1
          
       
          +------------------------------------------------------------+
          |                       NIC CMOS RESET                       |
          |------------------------------------------------------------|
          |                 Setting                  |       W1        |
          |------------------------------------------+-----------------|
          | »           |      Normal operation      |      Open       |
          |-------------+----------------------------+-----------------|
          |             |           Reset            |     Closed      |
          |------------------------------------------------------------|
          | Note: To reset the NIC's settings you must: close W1, turn |
          | on the computer, run the setup utility included with the   |
          | card, turn off the computer, open W1, and then reapply     |
          | power to the card.                                         |
          |                                                            |
          | When the card is reset the I/O base address will be set to |
          | 280h.                                                      |
          +------------------------------------------------------------+
       
          +------------------------------------------------------------+
          |                         CABLE TYPE                         |
          |------------------------------------------------------------|
          |                Type                |       W3A & W3B       |
          |------------------------------------+-----------------------|
          | » |     RG-58A/U 50ohm coaxial     |   Pins 2 & 3 closed   |
          |---+--------------------------------+-----------------------|
          |   | AUI transceiver via DB-15 port |   Pins 1 & 2 closed   |
          +------------------------------------------------------------+
       
          +------------------------------------------------------------+
          |                       BOOT ROM SIZE                        |
          |------------------------------------------------------------|
          |       Size       |        W9A         |        W9B         |
          |------------------+--------------------+--------------------|
          | » |     16KB     | Pins 1 & 2 closed  | Pins 1 & 2 closed  |
          |---+--------------+--------------------+--------------------|
          |   |     32KB     | Pins 2 & 3 closed  | Pins 1 & 2 closed  |
          |---+--------------+--------------------+--------------------|
          |   |     64KB     | Pins 2 & 3 closed  | Pins 2 & 3 closed  |
          +------------------------------------------------------------+
       
          +------------------------------------------------------------+
          |                    MISCELLANEOUS NOTES                     |
          |------------------------------------------------------------|
          | IRQ and Base I/O are set using the utility included with   |
          | the card.                                                  |
          +------------------------------------------------------------+