(TXT) View Source
       
       # DANPEX CORPORATION
       
          EN/2
       
          NIC Type         Ethernet                                      
          Transfer Rate    10Mbps                                        
          Data Bus         16-bit MCA                                    
          Topology         Linear bus                                    
          Wiring Type      RG-58A/U 50ohm coaxial                        
                                                                         
                           AUI transceiver via DB-15 port                
          Boot ROM         Available                                     
       
 (IMG) IMG 1
          
       
          +------------------------------------------------------------+
          |                         CABLE TYPE                         |
          |------------------------------------------------------------|
          |                Type                |      JP2B - JP2I      |
          |------------------------------------+-----------------------|
          | » |     RG-58A/U 50ohm coaxial     |   Pins 1 & 2 closed   |
          |---+--------------------------------+-----------------------|
          |   | AUI transceiver via DB-15 port |   Pins 2 & 3 closed   |
          +------------------------------------------------------------+
       
          +------------------------------------------------------------+
          |                     ONBOARD TERMINATOR                     |
          |------------------------------------------------------------|
          |            Setting            |            JP3             |
          |-------------------------------+----------------------------|
          | »         |     Disabled      |     Pins 1 & 2 closed      |
          |-----------+-------------------+----------------------------|
          |           |      Enabled      |     Pins 2 & 3 closed      |
          |------------------------------------------------------------|
          | Note:If the card is on either end of a linear bus network  |
          | segment, the onboard terminator may be used instead of an  |
          | external terminator                                        |
          +------------------------------------------------------------+
       
          +------------------------------------------------------------+
          |                FACTORY CONFIGURED SETTINGS                 |
          |------------------------------------------------------------|
          |           Jumper           |            Setting            |
          |----------------------------+-------------------------------|
          |            JP1             |            Unused             |
          |----------------------------+-------------------------------|
          |            JP2A            |       Pins 2 & 3 closed       |
          +------------------------------------------------------------+
       
          +------------------------------------------------------------+
          |                     DIAGNOSTIC LED(S)                      |
          |------------------------------------------------------------|
          |     LED     |    Status    |           Condition           |
          |-------------+--------------+-------------------------------|
          |    LED1     |      On      |   Data is being transmitted   |
          |-------------+--------------+-------------------------------|
          |    LED1     |     Off      | Data is not being transmitted |
          |-------------+--------------+-------------------------------|
          |    LED2     |      On      | Collision detected on network |
          |-------------+--------------+-------------------------------|
          |    LED2     |     Off      |       Normal operation        |
          |-------------+--------------+-------------------------------|
          |    LED3     |      On      |    Data is being received     |
          |-------------+--------------+-------------------------------|
          |    LED3     |     Off      |  Data is not being received   |
          +------------------------------------------------------------+