(TXT) View Source
       
       # ACTINET SYSTEMS, INC.
       
          ARCTALK 030
       
          NIC Type         ARCnet                                        
          Transfer Rate    2.5Mbps                                       
          Data Bus         32-bit 030 Processor direct slot              
          Topology         Star                                          
          Wiring Type      RG62/U 93ohm coaxial                          
          Boot ROM         Not available                                 
       
 (IMG) IMG 1
          
       
          +------------------------------------------------------------+
          |    SEGMENT LENGTH AND RESPONSE/RECONFIGURATION TIMEOUTS    |
          |------------------------------------------------------------|
          | Maximum  |  Response  | Reconfig. |     ET1     |   ET2    |
          |  Length  |    Time    |   Time    |             |          |
          |----------+------------+-----------+-------------+----------|
          |  22,000  |  74.7m s   |   840ms   | Pins 1 & 2  | Pins 1 & |
          |   feet   |            |           |   closed    | 2 closed |
          |----------+------------+-----------+-------------+----------|
          |  96,000  |  283.4m s  |  1680ms   | Pins 2 & 3  | Pins 1 & |
          |   feet   |            |           |   closed    | 2 closed |
          |----------+------------+-----------+-------------+----------|
          | 195,000  |  561.8m s  |  1680ms   | Pins 1 & 2  | Pins 2 & |
          |   feet   |            |           |   closed    | 3 closed |
          |----------+------------+-----------+-------------+----------|
          | 393,000  | 1118.6m s  |  1680ms   | Pins 2 & 3  | Pins 2 & |
          |   feet   |            |           |   closed    | 3 closed |
          |------------------------------------------------------------|
          | Note: All NICs on the network must have this option set    |
          | the same.                                                  |
          +------------------------------------------------------------+
       
          +------------------------------------------------------------+
          |                     DIAGNOSTIC LED(S)                      |
          |------------------------------------------------------------|
          |  LED   | Color  |  Status   |          Condition           |
          |--------+--------+-----------+------------------------------|
          |  LED1  | Green  |    On     |       Normal operation       |
          |--------+--------+-----------+------------------------------|
          |  LED1  | Green  | Blinking  |   There is a break in the    |
          |        |        |           | network (not necessarily at  |
          |        |        |           |          this card)          |
          |--------+--------+-----------+------------------------------|
          |  LED1  | Green  |    Off    |        Fault detected        |
          |------------------------------------------------------------|
          | Note: If a fault is detected, it can be any one or a       |
          | combination of the following:                              |
          |                                                            |
          | Card is not attached to an active network, the card is not |
          | selected in the control panel, AppleTalk is not enabled in |
          | the Chooser, the hybrid transceiver on the card is         |
          | defective, there are no active stations on the network,    |
          | the Mac's -12VDC power supply is malfunctioning, the hub   |
          | is defective, or there is a break in the network cable.    |
          +------------------------------------------------------------+