(TXT) View Source
# EVEREX SYSTEMS, INC.
EV-391
+------------------------------------------------------------+
+------------------------------------------------------------+
Data bus: 8-bit, ISA
Size: Full-length, full-height card
Hard drives supported: Two MFM ST506/412 drives
Floppy drives supported: None
(IMG) IMG 1
+------------------------------------------------------------+
| CONNECTIONS |
|------------------------------------------------------------|
| Function | Location |
|----------------------------------------------+-------------|
| 34-pin control cable connector-hard drive | J1 |
|----------------------------------------------+-------------|
| 20-pin data cable connector-drive 0 | J2 |
|----------------------------------------------+-------------|
| 20-pin data cable connector-drive 1 | J3 |
+------------------------------------------------------------+
+------------------------------------------------------------+
| USER CONFIGURABLE SETTINGS |
|------------------------------------------------------------|
| Function | Location | Setting |
|-----------------------------------+-----------+------------|
| » | Normal operation | W1 | pins 1 & 2 |
| | | | closed |
|---+-------------------------------+-----------+------------|
| | Factory test | W1 | pins 2 & 3 |
| | | | closed |
|---+-------------------------------+-----------+------------|
| » | Normal operation | W2 | pins 1 & 2 |
| | | | closed |
|---+-------------------------------+-----------+------------|
| | Factory test | W2 | pins 2 & 3 |
| | | | closed |
|---+-------------------------------+-----------+------------|
| » | BIOS enabled | W3 | closed |
|---+-------------------------------+-----------+------------|
| | BIOS disabled | W3 | open |
|---+-------------------------------+-----------+------------|
| » | I/O port address 320h | W4 | pins 2 & 3 |
| | | | closed |
|---+-------------------------------+-----------+------------|
| | I/O port address 324h | W4 | pins 1 & 2 |
| | | | closed |
|---+-------------------------------+-----------+------------|
| » | BIOS size 32K or 64K | W5 | pins 1 & 2 |
| | | | closed |
|---+-------------------------------+-----------+------------|
| | BIOS size 16K | W5 | pins 2 & 3 |
| | | | closed |
|---+-------------------------------+-----------+------------|
| » | 8 Head hard drive with RWC | W6 | pins 2 & 3 |
| | (Head Select 3 invalid) | | closed |
|---+-------------------------------+-----------+------------|
| | 16 head hard drive supported | W6 | pins 1 & 2 |
| | (Head Select 3 valid) | | closed |
|---+-------------------------------+-----------+------------|
| » | Hard drive interrupt is IRQ5 | W7 | pins 1 & 2 |
| | | | closed |
|---+-------------------------------+-----------+------------|
| | Hard drive interrupt is IRQ2 | W7 | pins 2 & 3 |
| | | | closed |
|------------------------------------------------------------|
| Note:SW1/switches 5, 6, 7, and 8 are reserved for BIOS |
| functions and should not be altered. |
+------------------------------------------------------------+
+------------------------------------------------------------+
| BIOS DRIVE TYPE TABLE - SW1 |
| |
| (FOR EPROM REV. 3.92A) |
|------------------------------------------------------------|
|# |Jumper 1 |Jumper 2 |Jumper 3 |Jumper 4 |Cap. |Hds. |Cyls.|
| | | | | | | | |
| | Drv. 1 | Drv. 1 | Drv. 0 | Drv. 0 | | | |
|--+---------+---------+---------+---------+-----+-----+-----|
|0 | closed | closed | closed | closed |42MB | 5 | 977 |
|--+---------+---------+---------+---------+-----+-----+-----|
|1 | open | closed | open | closed |21MB | 4 | 615 |
|--+---------+---------+---------+---------+-----+-----+-----|
|2 | closed | open | closed | open |10MB | 2 | 615 |
|--+---------+---------+---------+---------+-----+-----+-----|
|3 | open | open | open | open |10MB | 4 | 306 |
+------------------------------------------------------------+
+------------------------------------------------------------+
| MISCELLANEOUS TECHNICAL NOTES |
|------------------------------------------------------------|
| This controller has a built-in low-level format program. |
| To enter the program run the DEBUG utility supplied with |
| DOS and at the prompt enter: G=C800:5. |
+------------------------------------------------------------+