PARADYNE CORPORATION ==================== ACCULINK 3350 E1 Card Type Network Termination Unit NIC Type E1 Chip Set Unidentified I/O Options BNC connectors (2), auxiliary port (RJ-48), communication port (RJ-48), HDSL network interface via RJ-48 connector, test jacks (6), power jack 15-pin G.703 DTE port Maximum Data Rate 2.048Mbps Data Bus External +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Label | Function | Label | |-----------------+-------+--------------------------+-------| | Test jack - Lp1 | CN1 | Auxiliary port | CN8 | | HDSL line | | | | |-----------------+-------+--------------------------+-------| | Test jack - Lp2 | CN2 | Communication port | CN9 | | HDSL line | | | | |-----------------+-------+--------------------------+-------| | Test jack - E1 | CN3 | 15-pin DTE port | CN10 | | line in | | | | |-----------------+-------+--------------------------+-------| | Test jack - E1 | CN4 | HDSL network interface | CN11 | | line out | | via RJ-48 connector | | |-----------------+-------+--------------------------+-------| | Test jack - E1 | CN5 | BNC connector - receive | RX | | monitor In | | | | |-----------------+-------+--------------------------+-------| | Test jack - E1 | CN6 | BNC connector - transmit | TX | | monitor out | | | | |-----------------+-------+--------------------------+-------| | Power Jack | CN7 | | | +------------------------------------------------------------+ +------------------------------------------------------------+ | USER CONFIGURABLE SETTINGS | |------------------------------------------------------------| | Setting | Label | Position | |-----------------------------------------+-------+----------| | Open shield connection established | SW1 | On | |-----------------------------------------+-------+----------| | Earth shield connection established | SW1 | Off | |-----------------------------------------+-------+----------| | 120ohm balanced network interface | SW2 | In | | selected | | | |-----------------------------------------+-------+----------| | 75ohm unbalanced network interface | SW2 | Out | | selected | | | |------------------------------------------------------------| | Note: SW1 must be on when using the 120ohm interface | +------------------------------------------------------------+ +------------------------------------------------------------+ | DIAGNOSTIC LED(S) | |------------------------------------------------------------| | LED | Color | Status | Condition | |------+----------+----------+-------------------------------| | OK | Green | On | NTU power is on | |------+----------+----------+-------------------------------| | OK | Green | Blinking | NTU is downloading software | |------+----------+----------+-------------------------------| | OK | Green | Off | NTU power is off or detecting | | | | | a system failure | |------+----------+----------+-------------------------------| | FAIL | Yellow | On | Device error has been | | | | | detected | |------+----------+----------+-------------------------------| | FAIL | Yellow | Off | Device error has not been | | | | | detected | |------+----------+----------+-------------------------------| | FAIL | Yellow | Blinking | NTU is conducting a self test | |------+----------+----------+-------------------------------| | TST | Yellow | On | NTU is executing a loopback | | | | | or pattern test | |------+----------+----------+-------------------------------| | TST | Yellow | Off | NTU is not executing a test | |------+----------+----------+-------------------------------| | SIG1 | Green | On | NTU is receiving a | | | | | recoverable signal from | | | | | network on loop 1 | |------+----------+----------+-------------------------------| | SIG1 | Green | Off | NTU cannot recover the signal | | | | | from network on loop 1 | |------+----------+----------+-------------------------------| | SIG2 | Green | On | NTU is receiving a | | | | | recoverable signal from | | | | | network on loop 2 | |------+----------+----------+-------------------------------| | SIG2 | Green | Off | NTU cannot recover the signal | | | | | from network on loop 2 | |------+----------+----------+-------------------------------| | OOF | Yellow | On | Out of frame condition | | | | | detected on network | |------+----------+----------+-------------------------------| | OOF | Yellow | Off | Out of frame condition not | | | | | detected on network | |------+----------+----------+-------------------------------| | ALM | Yellow | On | Alarm condition detected on | | | | | network | |------+----------+----------+-------------------------------| | ALM | Yellow | Off | Alarm condition not detected | | | | | on network | |------+----------+----------+-------------------------------| | SIG | Green | On | A recoverable signal is being | | | | | received from G.703 DTE port | |------+----------+----------+-------------------------------| | SIG | Green | Off | NTU cannot recover the signal | | | | | from G.703 DTE port | |------+----------+----------+-------------------------------| | OFG | Yellow | On | Out of frame condition | | | | | detected on G.703 DTE signal | |------+----------+----------+-------------------------------| | OFG | Yellow | Off | Out of frame condition not | | | | | detected on G.703 DTE signal | |------+----------+----------+-------------------------------| | ALMG | Yellow | On | Alarm condition detected on | | | | | G.703 DTE signal | |------+----------+----------+-------------------------------| | ALMG | Yellow | Off | Alarm condition not detected | | | | | on G.703 DTE signal | |------+----------+----------+-------------------------------| | PDV | Yellow | On | A pulse density violation was | | | | | detected (and corrected) on | | | | | G.703 DTE signal | |------+----------+----------+-------------------------------| | PDV | Yellow | Off | A pulse density violation was | | | | | not detected on G.703 DTE | | | | | signal | |------+----------+----------+-------------------------------| | BPV | Yellow | On | A bipolar violation was | | | | | detected (and corrected) on | | | | | G.703 DTE signal | |------+----------+----------+-------------------------------| | BPV | Yellow | Off | A bipolar violation was not | | | | | detected on G.703 DTE signal | +------------------------------------------------------------+