NETCOMM LIMITED =============== THE OFFICIAL X-FILES MODEM 336 (MNP10) Card Type Modem (asynchronous) Chipset Unidentified Maximum Data Rate 33.6Kbps Maximum Fax Rate 14.4Kbps Data Modulation Bell 103A, 212A ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis, V.34 Rockwell V.FC Fax Modulation ITU-T V.17, V.27ter, V.29 Error MNP5, MNP10, V.42, V.42bis Correction/Compression Fax Class Class I & II Data Bus Serial 53447 +------------------------------------------------------------+ | DIAGNOSTIC LED(S) | |------------------------------------------------------------| | LED | Color | Status | Condition | |--------+-------+----------+--------------------------------| | TM | Red | On | Modem is in test mode | |--------+-------+----------+--------------------------------| | TM | Red | Off | Modem is not in test mode | |--------+-------+----------+--------------------------------| | TD | Red | Blinking | Modem is transmitting data | |--------+-------+----------+--------------------------------| | TD | Red | Off | Modem is not transmitting data | |--------+-------+----------+--------------------------------| | RD | Red | Blinking | Modem is receiving data | |--------+-------+----------+--------------------------------| | RD | Red | Off | Modem is not receiving data | |--------+-------+----------+--------------------------------| | OH | Red | On | Modem is off-hook | |--------+-------+----------+--------------------------------| | OH | Red | Off | Modem is on-hook | |--------+-------+----------+--------------------------------| | CD | Red | On | Carrier signal detected | |--------+-------+----------+--------------------------------| | CD | Red | Off | Carrier signal not detected | |--------+-------+----------+--------------------------------| | AA | Red | On | Auto-answer enabled | |--------+-------+----------+--------------------------------| | AA | Red | Off | Auto-answer disabled | |--------+-------+----------+--------------------------------| | AA | Red | Blinking | Phone is ringing | |--------+-------+----------+--------------------------------| | TR | Red | On | DTR signal is high | |--------+-------+----------+--------------------------------| | TR | Red | Off | DTR signal is low | |--------+-------+----------+--------------------------------| | CP | Red | On | Compression enabled | |--------+-------+----------+--------------------------------| | CP | Red | Off | Compression disabled | |--------+-------+----------+--------------------------------| | EC | Red | On | Error correction enabled | |--------+-------+----------+--------------------------------| | EC | Red | Off | Error correction disabled | |--------+-------+----------+--------------------------------| | POWER | Red | On | Power is on | |--------+-------+----------+--------------------------------| | POWER | Red | Off | Power is off | +------------------------------------------------------------+ +-------------------------------+ | MISCELLANEOUS TECHNICAL NOTES | |-------------------------------| | Diagram not available. | +-------------------------------+ +------------------------------------------------------------+ | SUPPORTED STANDARD COMMANDS | |------------------------------------------------------------| | Basic AT Commands | |------------------------------------------------------------| | +++, 'comma', A/ | |------------------------------------------------------------| | A, B, E, H, L, M, N, O, P, Q, T, V, W, X, Y, Z | |------------------------------------------------------------| | &C, &D, &F, &G, &K, &Q, &R, &S, &V, &W, &Y, &Z | |------------------------------------------------------------| | Extended AT Commands | |------------------------------------------------------------| | \A, \B, \G, \L, \N, \V | |------------------------------------------------------------| | %C, %E, %L, %Q | |------------------------------------------------------------| | Special AT Commands | |------------------------------------------------------------| | :E, *H, -K, )M, @M, +MS, -Q | |------------------------------------------------------------| | S-Registers | |------------------------------------------------------------| | S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12, | | S18, S24, S25, S29, S30, S32, S33, S38 | |------------------------------------------------------------| | S48, S82, S86, S95 | |------------------------------------------------------------| | Note: See MHI help file for complete information. | +------------------------------------------------------------+ +------------------------------------------------------------+ | UNIDENTIFIED COMMANDS | |------------------------------------------------------------| | Command | Default | |----------------------------+-------------------------------| | \K | Unidentified | |----------------------------+-------------------------------| | *S | Unidentified | +------------------------------------------------------------+ Proprietary AT Command Set +------------------------------------------------------------+ | CALLING TONE | |------------------------------------------------------------| | Type: | Configuration | |--------------+---------------------------------------------| | Format: | AT [cmds] #Cn [cmds] | |--------------+---------------------------------------------| | Description: | Controls whether the modem will send a V.25 | | | calling tone when originating a call. | |--------------+---------------------------------------------| | Note: | This command may not work on all THE | | | OFFICIAL X-FILES MODEM 336 (MNP10)s. | |--------------+---------------------------------------------| | Command | Function | |--------------+---------------------------------------------| | #C0 | Calling tone disabled. | |--------------+---------------------------------------------| | i #C1 | 1300Hz V.25 calling tone enabled. | +------------------------------------------------------------+ +------------------------------------------------------------+ | DIAL | |------------------------------------------------------------| | Type: | Immediate | |--------------+---------------------------------------------| | Format: | AT [cmds] D<#>;[cmds] | |--------------+---------------------------------------------| | Description: | Dials the telephone number indicated | | | according to any modifiers included in the | | | string. | |--------------+---------------------------------------------| | Command | Function | |--------------+---------------------------------------------| | DJ | MNP10 link will be negotiated at 1200bps | | | for this call. | |--------------+---------------------------------------------| | DK | MNP10 power level adjustment enabled for | | | this call. | |--------------+---------------------------------------------| | DL | Re-dial last number. | |--------------+---------------------------------------------| | DP | Pulse dialing enabled. | |--------------+---------------------------------------------| | DS=n | Dial stored telephone number n. | |--------------+---------------------------------------------| | DT | Tone dialing enabled. | |--------------+---------------------------------------------| | DW | Dialing resumed following dial tone | | | detection. | +------------------------------------------------------------+ +------------------------------------------------------------+ | DIAL (CON'T) | |------------------------------------------------------------| | Command | Function | |---------+--------------------------------------------------| | D, | Dialing paused for amount of time specified in | | | S8 register. | |---------+--------------------------------------------------| | D! | Flash function initiated. Modem commanded to go | | | off-hook for specified time before returning | | | on-hook. | |---------+--------------------------------------------------| | D@ | Wait for Quiet Answer function enabled. Modem | | | waits until a "quiet answer," a ring-back signal | | | followed by silence up to the time specified in | | | S7, is received prior to executing the rest of | | | the dial string. | |---------+--------------------------------------------------| | D^ | Calling tone disabled for this call. | |---------+--------------------------------------------------| | D; | Modem returned to idle state after dialing. The | | | semicolon can only be placed at the end of the | | | dial command. | +------------------------------------------------------------+ +------------------------------------------------------------+ | DISTINCTIVE RING | |------------------------------------------------------------| | Format: | AT [cmds] -SDR=n [cmds] | |----------------+-------------------------------------------| | Default: | 0 | |----------------+-------------------------------------------| | Range: | 0 - 7 | |----------------+-------------------------------------------| | Description: | Selects which distinctive ring signals | | | the modem will respond to and how it will | | | respond. | |------------------------------------------------------------| | Bit | Value | Function | |---------+--------+-----------------------------------------| | 0 | i 0 | Respond to ring type 1 as RING. | | | | | | | 1 | Respond to ring type 1 as RING1. | |------------------------------------------------------------| | 1 | i 0 | Respond to ring type 2 as RING. | | | | | | | 1 | Respond to ring type 2 as RING2. | |-------------+------+---------------------------------------| | 2 | i 0 | Respond to ring type 3 as RING. | | | | | | | 1 | Respond to ring type 3 as RING3. | +------------------------------------------------------------+ +------------------------------------------------------------+ | DISPLAY CONFIGURATION AND STATISTICS | |------------------------------------------------------------| | Type: | Immediate | |--------------+---------------------------------------------| | Format: | AT [cmds] \S [cmds] | |--------------+---------------------------------------------| | Description: | Displays the settings of all commands and | | | statistics about the current connection. | +------------------------------------------------------------+ +------------------------------------------------------------+ | DISPLAY INFORMATION | |------------------------------------------------------------| | Type: | Immediate | |--------------+---------------------------------------------| | Format: | AT [cmds] In [cmds] | |--------------+---------------------------------------------| | Description: | Displays information requested about the | | | modem. | |--------------+---------------------------------------------| | Command | Function | |--------------+---------------------------------------------| | I0 | Displays product identification code. | |--------------+---------------------------------------------| | I1 | Displays ROM checksum. | |--------------+---------------------------------------------| | I2 | Tests and displays ROM checksum result. | |--------------+---------------------------------------------| | I3 | Displays firmware revision. | |--------------+---------------------------------------------| | I4 | Displays feature bitmap. | |--------------+---------------------------------------------| | I9 | Displays product name and version. | |--------------+---------------------------------------------| | I100 | Plays the theme song to the X-Files. | +------------------------------------------------------------+ +------------------------------------------------------------+ | FAX/DATA SWITCHING | |------------------------------------------------------------| | Type: | Configuration | |--------------+---------------------------------------------| | Format: | AT [cmds] *SMn [cmds] | |--------------+---------------------------------------------| | Description: | Selects whether the modem will | | | automatically detect the type of incoming | | | call and switch to the appropriate mode. | |--------------+---------------------------------------------| | Command | Function | |--------------+---------------------------------------------| | i *SM0 | Fax/data switching disabled. | |--------------+---------------------------------------------| | *SM1 | Fax/data switching enabled. | +------------------------------------------------------------+ +------------------------------------------------------------+ | FAX/DATA SWITCHING - MANUAL | |------------------------------------------------------------| | Type: | Configuration | |--------------+---------------------------------------------| | Format: | AT [cmds] *SC=<#> [cmds] | |--------------+---------------------------------------------| | Description: | Sets the modem to switch to fax mode when | | | it receives the indicated DTMF digit. | +------------------------------------------------------------+ +------------------------------------------------------------+ | FAX/DATA SWITCHING MODE | |------------------------------------------------------------| | Type: | Configuration | |--------------+---------------------------------------------| | Format: | AT [cmds] *STn [cmds] | |--------------+---------------------------------------------| | Description: | Selects how the modem switches modes | | | between data and fax. | |--------------+---------------------------------------------| | Command | Function | |--------------+---------------------------------------------| | *ST0 | Manual switching only. | |--------------+---------------------------------------------| | *ST1 | Automatic switching only. | |--------------+---------------------------------------------| | i *ST2 | Automatic or manual switching. | +------------------------------------------------------------+ +------------------------------------------------------------+ | RINGBACK SIGNAL | |------------------------------------------------------------| | Type: | Configuration | |--------------+---------------------------------------------| | Format: | AT [cmds] *SSn [cmds] | |--------------+---------------------------------------------| | Description: | Selects whether the modem will transmit a | | | ringback signal while the line is ringing. | |--------------+---------------------------------------------| | Command | Function | |--------------+---------------------------------------------| | i *SS0 | Ringback signal disabled. | |--------------+---------------------------------------------| | *SS1 | Ringback signal enabled. |