ACTIONTEC ELECTRONICS, INC
==========================

   COMNET ETHERNET+FAX/MODEM 288

   Card Type              Fax, Modem (synchronous/asynchronous),  
                          Network Interface Card                  
   Chip Set               Unidentified                            
   I/O Options            Ethernet 10BaseT connector, Ethernet    
                          10Base2 connector                       
   NIC Type               Ethernet                                
   Network Transfer Rate  100Mbps                                 
   Maximum Modem Rate     28.8Kbps                                
   Maximum Fax Rate       14.4Kbps                                
   Data Bus               PCMCIA Type II                          
   Fax Class              Class I & II                            
   Data Modulation        Bell 103/212A                           
   Protocol                                                       
                          ITU-T V.21, V.22, V.22bis, V.23, V.32,  
                          V.32bis, V.34                           
   Fax Modulation         ITU-T V.17, V.21CH2, V.27ter, V.29      
   Protocol               
   Error                  MNP5, V.42, V.42bis                     
   Correction/Compression 
   Topology               Linear Bus, Star, Ring                  
   Wiring Type            Unshielded twisted pair                 
                                                                  
                          RG-58A/U 50ohm coaxial                  
   Boot ROM               Not available                           

<gopher://bitreich.org/I/th99/t/A-B/52294-1.png>
   

   +------------------------------------------------------------+
   |                        CONNECTIONS                         |
   |------------------------------------------------------------|
   |       Function        |     Label      | Function  | Label |
   |------------------------------------------------------------|
   | RJ-45 UTP/10BaseT |   CN1   | RG-58A              |  CN2   |
   |                   |         | coaxial/10Base2     |        |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                     DIAGNOSTIC LED(S)                      |
   |------------------------------------------------------------|
   |  LED  | Color |  Status  |            Condition            |
   |-------+-------+----------+---------------------------------|
   | TX/RX | Green | Blinking |   Transmitting/receiving data   |
   |       |       |          |         to/from network         |
   |-------+-------+----------+---------------------------------|
   | TX/RX | Green |   Off    | Not transmitting/receiving data |
   |       |       |          |         to/from network         |
   |-------+-------+----------+---------------------------------|
   | LINK  | Green |    On    | Link integrity good on 10BaseT  |
   |       |       |          |             network             |
   |-------+-------+----------+---------------------------------|
   | LINK  | Green |   Off    |    Link integrity broken on     |
   |       |       |          |         10BaseT network         |
   +------------------------------------------------------------+

   +---------------------------------------------------------+
   |                  SUPPORTED COMMAND SET                  |
   |---------------------------------------------------------|
   |                    Basic AT Commands                    |
   |---------------------------------------------------------|
   | AT, '+++', 'Comma', A/                                  |
   |---------------------------------------------------------|
   | A, D, E, H, L, M, V, W, Z                               |
   |---------------------------------------------------------|
   | &C, &D, &F, &W, &X, &Y, &Z                              |
   |---------------------------------------------------------|
   |                       S Registers                       |
   |---------------------------------------------------------|
   | S0, S6, S7, S8                                          |
   |---------------------------------------------------------|
   | Note: See MHI Help file for full command documentation. |
   +---------------------------------------------------------+