MACNET ====== SE470E (VER. A) NIC Type: Ethernet Transfer Rate: 10Mbps Data Bus: 32-bit SE Processor direct slot (Apple) Topology: Linear Bus Star Wiring Type AUI transceiver via DB-15 port RG-58A/U 50ohm coaxial Shielded/Unshielded twisted pair Boot ROM Available +------------------------------------------------------------+ | CABLE TYPE | |------------------------------------------------------------| | Type | SW1 | |----------------------------------+-------------------------| | AUI transceiver via DB-15 port | Position 2 | |----------------------------------+-------------------------| | RG-58A/U 50ohm coaxial | Position 3 | |----------------------------------+-------------------------| | Shielded/unshielded twisted pair | Position 1 | +------------------------------------------------------------+ +------------------------------------------------------------+ | ON-BOARD RAM | |------------------------------------------------------------| | Setting | JP1 | |--------------------------------+---------------------------| |>> | 64KB | Closed | |------+-------------------------+---------------------------| | | 16KB | Open | |------------------------------------------------------------| | Note:The location of JP1 is not specified in | | manufacturer's documentation. | +------------------------------------------------------------+ +------------------------------------------------------------+ | BOOT ROM | |------------------------------------------------------------| | Setting | JP2 | JP3 | |----------------------------------+------------+------------| |>> | 27128 ROM chip installed | Closed | N/A | |-------+--------------------------+------------+------------| | | 27256 ROM chip installed | Open | N/A | |-------+--------------------------+------------+------------| |>> | 74LS471 ROM chip | N/A | Closed | | | installed | | | |-------+--------------------------+------------+------------| | | PJ2 ROM chip installed | N/A | Open | |------------------------------------------------------------| | Note:The locations of JP2 and JP3 are not specified in | | manufacturer's documentation. | +------------------------------------------------------------+ +------------------------------------------------------------+ | DIAGNOSTIC LEDS | |------------------------------------------------------------| | LED | Color | Status | Condition | |-------+-------+--------+-----------------------------------| | LED 1 | Green | On | Data is being transmitted or | | | | | received | |-------+-------+--------+-----------------------------------| | LED 1 | Green | Off | Data is not being transmitted or | | | | | received | |-------+-------+--------+-----------------------------------| | LED 2 | Red | On | Twisted pair network connection | | | | | is good | |-------+-------+--------+-----------------------------------| | LED 2 | Red | Off | Twisted pair network connection | | | | | is broken | +------------------------------------------------------------+