CABLETRON SYSTEMS, INC. ======================= T2015 NIC Type Token-Ring Transfer Rate 4/16Mbps Data Bus 16-bit ISA Topology Ring Wiring Type Unshielded twisted pair Shielded twisted pair (DB-9 port) Boot ROM Not available +------------------------------------------------------------+ | CLOCK SOURCE | |------------------------------------------------------------| | Setting | JP1 | |--------------------------------------+---------------------| |>> | Clock on card (Asynchronous | Pins 1 & 2 closed | | | operation) | | |------+-------------------------------+---------------------| | | Data bus clock (Synchronous | Pins 2 & 3 closed | | | operation) | | |------------------------------------------------------------| | Note: On some systems the data bus timing is not truly IBM | | PC/AT compatible. If the card is not | | initializing, using the data bus clock may allow the card | | to operate properly. | +------------------------------------------------------------+ +------------------------------------------------------------+ | I/O BASE ADDRESS | |------------------------------------------------------------| | Address | SW1/1 | SW1/2 | |--------------------+-------------------+-------------------| | 0A20h | On | On | |--------------------+-------------------+-------------------| | 0A80h | Off | On | |--------------------+-------------------+-------------------| | 1A20h | On | Off | |--------------------+-------------------+-------------------| | 1A80h | Off | Off | +------------------------------------------------------------+ +------------------------------------------------------------+ | DIAGNOSTIC LED(S) | |------------------------------------------------------------| | LED | Color | Status | Condition | |-------+---------+---------+--------------------------------| | LED1 | Yellow | On | Data is being transmitted or | | | | | received | |-------+---------+---------+--------------------------------| | LED1 | Yellow | Off | Data is not being transmitted | | | | | or received | |-------+---------+---------+--------------------------------| | LED2 | Green | On | Network connection is good | |-------+---------+---------+--------------------------------| | LED2 | Red | On | Network connection is broken | |-------+---------+---------+--------------------------------| | LED3 | Green | On | Card is set to 4Mbps operation | |-------+---------+---------+--------------------------------| | LED4 | Yellow | On | Card is set to 16Mbps | | | | | operation | |------------------------------------------------------------| | Note:LED2 is a two color LED. LED2 will light red when | | power is first applied to the card. | +------------------------------------------------------------+