DANPEX CORPORATION ================== EN-2010BT NIC Type Ethernet Transfer Rate 10Mbps Data Bus 16-bit ISA Topology Star Wiring Type Shielded/Unshielded twisted pair AUI transceiver via DB-15 port Boot ROM Available +------------------------------------------------------------+ | DIAGNOSTIC LED(S) | |------------------------------------------------------------| | LED | Color | Status | Condition | |------+--------+--------+-----------------------------------| | LED1 | Green | On | Data is being received | |------+--------+--------+-----------------------------------| | LED1 | Green | Off | Data is not being received | |------+--------+--------+-----------------------------------| | LED2 | Red | On | Card is transmitting constantly | | | | | (Jabber) | |------+--------+--------+-----------------------------------| | LED2 | Red | Off | Normal operation | |------+--------+--------+-----------------------------------| | LED3 | Green | On | Data is being transmitted | |------+--------+--------+-----------------------------------| | LED3 | Green | Off | Data is not being transmitted | |------+--------+--------+-----------------------------------| | LED4 | Yellow | On | Collision detected on network | |------+--------+--------+-----------------------------------| | LED4 | Yellow | Off | No collisions detected on network | +------------------------------------------------------------+ +------------------------------------------------------------+ | SEGMENT LENGTH | |------------------------------------------------------------| | Length | JP1 | |-----------------------------------+------------------------| |>> | Less than 100m | Pins 2 & 3 closed | |--------+--------------------------+------------------------| | | Greater than 100m | Pins 1 & 2 closed | |------------------------------------------------------------| | Note:Segment length is the total length of cable between | | the card and the multiport repeater (MPR). | +------------------------------------------------------------+ +------------------------------------------------------------+ | SIGNAL QUALITY ERROR (SQE) TEST | |------------------------------------------------------------| | Setting | JP2 | |-------------------------------+----------------------------| |>> | Disabled | Pins 2 & 3 closed | |-----------+-------------------+----------------------------| | | Enabled | Pins 1 & 2 closed | |------------------------------------------------------------| | Note:The Signal Quality Error (SQE) test is a test of the | | collision circuitry and path. | +------------------------------------------------------------+ +------------------------------------------------------------+ | LINK INTEGRITY TEST | |------------------------------------------------------------| | Setting | JP3 | |-------------------------------+----------------------------| |>> | Enabled | Pins 1 & 2 closed | |-----------+-------------------+----------------------------| | | Disabled | Pins 2 & 3 closed | |------------------------------------------------------------| | Note:The link integrity test is valid only when the cable | | type is shielded/unshielded twisted pair. | +------------------------------------------------------------+ +------------------------------------------------------------+ | CABLE TYPE | |------------------------------------------------------------| | Type | W1 - W6 | |--------------------------------------+---------------------| |>> | Shielded/Unshielded twisted pair | Pins 1 & 2 closed | |---+----------------------------------+---------------------| | | AUI transceiver via DB-15 port | Pins 2 & 3 closed | +------------------------------------------------------------+ +------------------------------------------------------------+ | COMPATIBILITY MODE | |------------------------------------------------------------| | Setting | W7 | |---------------------------------------+--------------------| |>> | Disabled | Open | |--------------+------------------------+--------------------| | | Enabled | Closed | |------------------------------------------------------------| | Note:If the system in which the card is to be installed | | uses a Chips & Technology chipset, or if the system does | | not boot properly with the card installed, compatibility | | mode should be enabled (W7 closed). | +------------------------------------------------------------+ +------------------------------------------------------------+ | I/O BASE ADDRESS & BOOT ROM BASE ADDRESS | |------------------------------------------------------------| | I/O Address | Boot ROM Address | W8 | W9 | |----------------+----------------------+----------+---------| |>> | 300h | C8000h | Closed | Closed | |------+---------+----------------------+----------+---------| | | 320h | CC000h | Open | Closed | |------+---------+----------------------+----------+---------| | | 340h | D0000h | Closed | Open | |------+---------+----------------------+----------+---------| | | 360h | N/A | Open | Open | |------------------------------------------------------------| | Note:I/O address 360h cannot be used when a boot ROM is | | installed. | +------------------------------------------------------------+ +------------------------------------------------------------+ | BOOT ROM | |------------------------------------------------------------| | Setting | W10 | |---------------------------------+--------------------------| |>> | Disabled | Open | |---+-----------------------------+--------------------------| | | Enabled | Closed | +------------------------------------------------------------+ +------------------------------------------------------------+ | INTERRUPT REQUEST | |------------------------------------------------------------| | IRQ | W11 | W12 | W13 | W14 | |------------+-----------+-----------+-----------+-----------| | | 2/9 | Closed | Open | Open | Open | |---+--------+-----------+-----------+-----------+-----------| |>> | 3 | Open | Closed | Open | Open | |---+--------+-----------+-----------+-----------+-----------| | | 4 | Open | Open | Closed | Open | |---+--------+-----------+-----------+-----------+-----------| | | 5 | Open | Open | Open | Closed | +------------------------------------------------------------+