MOXA TECHNOLOGIES CO., LTD
==========================

   C102H, C102HI, C102HIS, C102P

   Card Type           Serial controller                          
   Chip Set            Unidentified                               
   I/O Options         Serial ports (2 RS-422/485)                
   Data Bus            16-bit ISA (EISA compatible)               
   Card Size           Full-height, Half-length card              

<gopher://bitreich.org/I/th99/i/M-O/54750-1.png>
   

   +------------------------------------------------------------+
   |                        CONNECTIONS                         |
   |------------------------------------------------------------|
   |       Function       | Label |      Function       | Label |
   |----------------------+-------+---------------------+-------|
   | Serial Port 1        |  CN1  | Serial Port 2       |  CN2  |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                 USER CONFIGURABLE SETTINGS                 |
   |------------------------------------------------------------|
   |                Function                | Label | Position  |
   |----------------------------------------+-------+-----------|
   |>>  | CAP address 0x180 enabled         |  JP1  |   Open    |
   |----+-----------------------------------+-------+-----------|
   |    | CAP address 0x180 disabled        |  JP1  |  Closed   |
   |------------------------------------------------------------|
   | Note: When disabled CAP address is forced to 0xA700        |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |               MISCELLANEOUS TECHNICAL NOTES                |
   |------------------------------------------------------------|
   | Note: Base I/O address and IRQ settings are configured via |
   | software written to EEPROM. Normally the default settings  |
   | should be used unless another device cannot be configured  |
   | to an address other than 0x180. If JP1 is shorted this     |
   | will force the Configuration Access Port (CAP) to address  |
   | 0xA700.                                                    |
   +------------------------------------------------------------+