TEKRAM TECHNOLOGY CO., LTD. =========================== DC-600CD Data bus: 16-bit, ISA Size: Half-length, half-height card Hard drive Four IDE (AT) Interface drives supported: Floppy drives Two 360KB, 720KB, 1.2MB, or 1.44MB drives supported: +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Location | |-------------------------------------------------+----------| | 40-pin IDE (AT) Interface connector - IDE-0 | CN1 | |-------------------------------------------------+----------| | 40-pin IDE (AT) Interface connector - IDE-1 | CN2 | |-------------------------------------------------+----------| | 34-pin control cable connector - floppy drive | CN3 | |-------------------------------------------------+----------| | 40-pin IDE (AT) flat cable connector - CD-ROM | CN4 | | drive | | |-------------------------------------------------+----------| | 4-pin connector - drive active LED | JP1 | |-------------------------------------------------+----------| | 4-pin connector - cache error speaker | JP2 | |-------------------------------------------------+----------| | Factory configured - do not alter | JP3 | +------------------------------------------------------------+ +------------------------------------------------------------+ | DRIVE ACTIVE LED ERROR CODES (IMMEDIATELY AFTER POWER-UP) | |------------------------------------------------------------| | Status | Function | |----------------------------+-------------------------------| | One short flash | No cache DRAM installed | |----------------------------+-------------------------------| | Two short flashes | CPU error | |----------------------------+-------------------------------| | Three short flashes | SRAM error | |----------------------------+-------------------------------| | Four short flashes | Timer error | +------------------------------------------------------------+ +------------------------------------------------------------+ | MISCELLANEOUS TECHNICAL NOTES | |------------------------------------------------------------| | Some versions of this board have two 512KB x 8 DRAM chips | | mounted in place of Bank 0. In such a case the board will | | work without additional memory. In all other cases a pair | | of 256KB, 1MB, or 4MB SIMM modules must be installed in | | Bank 0 for the board to function. | +------------------------------------------------------------+