KIMPSION INTERNATIONAL
======================

   WA6-V

   Data bus: 16-bit, ISA

   Size: Full-length, half-height card

   Hard drives supported:  Two MFM ST506/412 drives

   Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB

   Sector interleave:  1:1

   Maximum heads/cyl.: 16 heads and 2048 cylinders

<gopher://bitreich.org/I/th99/c/I-L/20119-1.png>
   

   +------------------------------------------------------------+
   |                        CONNECTIONS                         |
   |------------------------------------------------------------|
   |                 Function                  |    Location    |
   |-------------------------------------------+----------------|
   | 4-pin connector-drive active LED          |      CN1       |
   |-------------------------------------------+----------------|
   | 20-pin data cable connector-drive 1       |      CN2       |
   |-------------------------------------------+----------------|
   | 20-pin data cable connector-drive 0       |      CN3       |
   |-------------------------------------------+----------------|
   | 34-pin control cable connector-hard drive |      CN4       |
   |-------------------------------------------+----------------|
   | 34-pin data cable connector-floppy drive  |      CN7       |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                 USER CONFIGURABLE SETTINGS                 |
   |------------------------------------------------------------|
   |              Function              | Location |  Setting   |
   |------------------------------------+----------+------------|
   |>> | Hard drive port address is     |   JP5    | pins 2 & 3 |
   |   | 1F0-1F7h                       |          |   closed   |
   |---+--------------------------------+----------+------------|
   |   | Hard drive port address is     |   JP5    | pins 1 & 2 |
   |   | 170-177h                       |          |   closed   |
   |---+--------------------------------+----------+------------|
   |>> | Floppy drive port address is   |   JP6    | pins 2 & 3 |
   |   | 3F0-3F7h                       |          |   closed   |
   |---+--------------------------------+----------+------------|
   |   | Floppy drive port address is   |   JP6    | pins 1 & 3 |
   |   | 370-377h                       |          |   closed   |
   |---+--------------------------------+----------+------------|
   |>> | Bracket ground option not used |   JP8    |    open    |
   |---+--------------------------------+----------+------------|
   |   | Connects bracket to board      |   JP8    |   closed   |
   |   | ground                         |          |            |
   |---+--------------------------------+----------+------------|
   |>> | Pre-compensation set at 125ns. |   JP9    |    open    |
   |---+--------------------------------+----------+------------|
   |   | Pre-compensation set at 187ns. |   JP9    |   closed   |
   |---+--------------------------------+----------+------------|
   |>> | Single-speed floppy drive      |   JP10   |    open    |
   |   | supported                      |          |            |
   |---+--------------------------------+----------+------------|
   |   | Dual-speed floppy drive        |   JP10   |   closed   |
   |   | supported                      |          |            |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |               MISCELLANEOUS TECHNICAL NOTES                |
   |------------------------------------------------------------|
   | Notes: Do not combine single- and dual-speed floppy drives |
   | on the same controller card.                               |
   |                                                            |
   | There is no on-board BIOS format program. You must use     |
   | software to low-level your drives.                         |
   |                                                            |
   | This controller is compatible with the Western Digital     |
   | WD1006V-MM2.                                               |
   +------------------------------------------------------------+