EMULEX CORPORATION ================== MD25A, MD26A +------------------------------------------------------------+ +------------------------------------------------------------+ Data bus: None (SCSI to ESDI interface) Size: Drive card Hard drives supported: SCSI to four RLL ESDI drives Floppy drives supported: None +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Location | |------------------------------------------------+-----------| | 34-pin control cable connector-hard drive | J1 | |------------------------------------------------+-----------| | 20-pin data cable connector-drive 0 | J2 | |------------------------------------------------+-----------| | 20-pin data cable connector-drive 1 | J3 | |------------------------------------------------+-----------| | 10-pin connector-user panel (factory use only) | J4 | |------------------------------------------------+-----------| | 14-pin connector-test (factory use only) | J5 | |------------------------------------------------+-----------| | 50-pin SCSI connector- to host adapter | J6 | |------------------------------------------------+-----------| | 4-pin connector-DC power | J7 | |------------------------------------------------+-----------| | 20-pin data cable connector-drive 2 | J8 | |------------------------------------------------+-----------| | 20-pin data cable connector-drive 3 | J9 | |------------------------------------------------+-----------| | 10-pin connector-user panel (factory use only) | J10 | +------------------------------------------------------------+ +------------------------------------------------------------+ | USER CONFIGURABLE SETTINGS | |------------------------------------------------------------| | Function | Location | Setting | |-----------------------------------+--------------+---------| |>> | Soft error reporting disabled | SW1/switch 4 | on | |---+-------------------------------+--------------+---------| | | Soft error reporting enabled | SW1/switch 4 | off | |---+-------------------------------+--------------+---------| |>> | Sector size set to 512 bytes | SW1/switch 5 | off | |---+-------------------------------+--------------+---------| | | Sector size set to 256 bytes | SW1/switch 5 | on | |---+-------------------------------+--------------+---------| |>> | Spindle motor starts on | SW1/switch 6 | off | | | power-up | | | |---+-------------------------------+--------------+---------| | | Spindle motor starts on | SW1/switch 6 | on | | | command | | | |---+-------------------------------+--------------+---------| |>> | SCSI parity check disabled | SW1/switch 7 | off | |---+-------------------------------+--------------+---------| | | SCSI parity check enabled | SW1/switch 7 | on | |---+-------------------------------+--------------+---------| | | Not used | SW1/switch 8 | N/A | +------------------------------------------------------------+ +------------------------------------------------------------+ | SCSI ADDRESS | |------------------------------------------------------------| | SCSI ID | SW1/switch 1 | SW1/switch 2 | SW1/switch 3 | |------------+---------------+---------------+---------------| | | 0 | off | off | off | |----+-------+---------------+---------------+---------------| | | 1 | on | off | off | |----+-------+---------------+---------------+---------------| | | 2 | off | on | off | |----+-------+---------------+---------------+---------------| | | 3 | on | on | off | |----+-------+---------------+---------------+---------------| | | 4 | off | off | on | |----+-------+---------------+---------------+---------------| | | 5 | on | off | on | |----+-------+---------------+---------------+---------------| | | 6 | off | on | on | |----+-------+---------------+---------------+---------------| |>> | 7 | on | on | on | +------------------------------------------------------------+