DATA TECHNOLOGY CORPORATION =========================== DTC5287CR, DTC5287I, DTC7287 +------------------------------------------------------------+ +------------------------------------------------------------+ Data bus: 16-bit, ISA Size: Full-length, full-height card Hard drives supported: Two RLL ST506/412 drives with 17,32, or 60 sector mapping Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB Sector interleave: DTC5287CR: 1:1 DTC5287i: 2:1 DTC7287: 1:1 +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Location | |-------------------------------------------+----------------| | 34-pin data cable connector-floppy drive | J1 | |-------------------------------------------+----------------| | 34-pin control cable connector-hard drive | J2 | |-------------------------------------------+----------------| | 20-pin data cable connector-drive 0 | J3 | |-------------------------------------------+----------------| | 20-pin data cable connector-drive 1 | J4 | |-------------------------------------------+----------------| | 4-pin connector-drive active LED | J5 | +------------------------------------------------------------+ +------------------------------------------------------------+ | USER CONFIGURABLE SETTINGS | |------------------------------------------------------------| | Function | Location | Setting | |---------------------------------------+----------+---------| |>> | Floppy drive data transfer rate | W4 | open | | | is 500KHz | | | |---+-----------------------------------+----------+---------| | | Floppy drive data transfer rate | W4 | closed | | | is 250KHz | | | |---+-----------------------------------+----------+---------| |>> | Hardware drive select mode | W5 | closed | | | | | | | | (drive number is driven directly | | | | | to the interface) | | | |---+-----------------------------------+----------+---------| | | Firmware drive select mode | W5 | open | | | | | | | | (drive number is intercepted by | | | | | controller firmware) | | | |---+-----------------------------------+----------+---------| |>> | Auto-deselect enabled | W6 | closed | |---+-----------------------------------+----------+---------| | | Auto-deselect disabled | W6 | open | |---+-----------------------------------+----------+---------| |>> | Floppy drive precompensation | W7 | open | | | scaled by data rate: | | | | | | | | | | 500KHz=125ns, 300KHz=208ns, | | | | | 250KHz=250ns | | | |---+-----------------------------------+----------+---------| | | Floppy drive precompensation is | W7 | closed | | | 125ns | | | |---+-----------------------------------+----------+---------| |>> | Factory configured - do not alter | W8 | closed | |---+-----------------------------------+----------+---------| |>> | BIOS address is C800h | W9 | open | |---+-----------------------------------+----------+---------| | | BIOS address is D800h | W9 | closed | |---+-----------------------------------+----------+---------| |>> | BIOS enabled | W10 | closed | |---+-----------------------------------+----------+---------| | | BIOS disabled | W10 | open | +------------------------------------------------------------+ +------------------------------------------------------------+ | HARD DRIVE PORT ADDRESS | |------------------------------------------------------------| | Address | W2 | W3 | |-----------------------------------------+---------+--------| |>> | Port addresses are 1F0-1F7 3F2-3F7h | open | open | |---+-------------------------------------+---------+--------| | | Port addresses are 170-177 372-377h | closed | closed | +------------------------------------------------------------+