ACCULOGIC, INC. =============== VESAPPORT Data bus: 32-bit VL-bus Size: Three-quarter length, full-height card Hard drive Up to seven Fast SCSI-2 devices, up to supported: fifteen Fast and Wide SCSI-3 devices Floppy drives Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB supported: drives +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Location | |------------------------------------------+-----------------| | 34-pin cable connector - floppy drive | J3 | |------------------------------------------+-----------------| | 4-pin connector - drive active LED | J4 | |------------------------------------------+-----------------| | 50-pin SCSI connector - internal | J5 | |------------------------------------------+-----------------| | 50-pin SCSI connector - external | J6 | |------------------------------------------+-----------------| | 68-pin SCSI connector - internal | J10 | |------------------------------------------+-----------------| | Power connector | JP8 | +------------------------------------------------------------+ +------------------------------------------------------------+ | USER CONFIGURABLE SETTINGS | |------------------------------------------------------------| | Function | Location | Setting | |--------------------------------+------------+--------------| |>> | Floppy drive interface | JP2 | Pins 2 & 3 | | | enabled as primary | | closed | |-----+--------------------------+------------+--------------| | | Floppy drive interface | JP2 | Pins 1 & 2 | | | disabled | | closed | |-----+--------------------------+------------+--------------| |>> | Normally configure board | SW1 | Position 2 | | | during installation | | | |-----+--------------------------+------------+--------------| | | Lock configuration | SW1 | Position 1 | | | during installation | | | |-----+--------------------------+------------+--------------| | | Reset configuration | SW1 | Position 3 | |------------------------------------------------------------| | Note: SW1 is set to normal unless two ISApport boards are | | installed on the same system. In this | | | | situation, the boards are installed sequentially. First, | | board 1 is installed and configured. Then, | | | | its SW1 is set to lock, and board 2 is installed and | | configured with its SW1 set to normal. | | | | The reset setting for SW1 is unidentified. | +------------------------------------------------------------+ +------------------------------------------------------------+ | MISCELLANEOUS TECHNICAL NOTES | |------------------------------------------------------------| | VESApport can only be configured with devices chained off | | two SCSI connectors (e.g. J5 and J6, J5 and J10, or J6 and | | J10). The board does not work when devices are chained off | | all three connectors. | +------------------------------------------------------------+