C.T.S. TRANSFORMER SOFTWARE


TRANSIRD  is the run chip for the IRD units.
 TRANS21  is the run chip for 2100 stand alone units.
TRANSRAM  is the load chip for all units
TRANUTIL  is the utility reader chip used to read both the monthly
          authorizations and the working keys.

LOCATIONS FOR THE TRANSRAM:
The Monthly keys are located at 0100 and 0163.
The ID# first four bytes are located at 0235.
The keys are located at 2000.
EXAMPLE:
2000: 00 00 00 00 00 00 00(00) 11 11 11 11 11 11 11 (00)
      22 22 22 22 22 22 22(00) 33 33 33 33 33 33 33 (00)

Seven bytes then a 00, seven more then 00, seven more then 00,
then seven more then 00.

You can install a set of backup keys at location 2E00.
Insatll backup ID# at 2E20 first four bytes.

TRANUTIL:has a number of features press #5 and this will repair
         a lost FF checksum. Do not use unless you want to
         cancel all the U-7 information.  Use this function if
         you are installing the software in a 2000 unit.

         Press setup and 6 to read monthly keys.
         Press setup and 7 to read working keys.
         Press setup and 8 to read keys in a 2000.
         Press setup and 9 to load keys in a 2000.

TRANSIRD AND TRANS21:
         These are the run chips for all units.  Use the IRD in
         all units other than stand alones.  Pressing setup and
         9 will give you the options to choose from.  Pressing
         number 5 will put the box into the 0 key mode. Press
         number 6 and the unit uses the clone number.  The
         message bar at the bottom of the screen will tell you
         what method you are presently using.  Pressing number 7
         allows you to tell the unit how many banks to search if
         you are using the 0 key mode.  Pressing 8 allows you to
         enter working keys to the banks of information stored in
         the unit, itis used again only in the 0 key mode.

USING THE BACKUP KEYS:

At any time you can switch to the backup set of keys by pressing
setup up and then pressing the left hand arrow 10 times. The
screen will flash and the unit switches to the backup keys.  You
will have to stay in the 0 key mode till the unit takes a hit
then you can switch to the clone again.

Please let me know what you think of the software and any comments
as to how we can improve it.

IMPORTANT THIS SOFTWARE WILL TAKE HITS ONLY ON AUTHORIZED CHANNELS
IT REJECTS INFORMATION COMING FROM UNAUTHORIZED CHANNELS.  CERTAIN
ELECTRONIC COUNTER MEASURES ARE SENDING BAD INFO TO UNITS IF THEY
ARE TUNED TO AN UNAUTHORIZED CHANNEL.
.W#04?
Downloaded From P-80 International Information Systems 304-744-2253